REMOVE V-BANK COVER SUB-ASSEMBLY
Using both hands, lift the rear side of the cover upwards to detach the 4 clips labeled B. Then slide the cover toward the front of the vehicle to detach the 2 clips labeled A and remove the V-bank cover sub-assembly.
Note
The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.
When detaching the clips labeled A, be sure to slide the cover toward the front of the vehicle.
REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY
Remove the 5 clips labeled A.
Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.
REMOVE NO. 1 AIR CLEANER INLET
Remove the 2 bolts.
Hold the No. 1 air cleaner inlet by the protrusions labeled A and labeled B, and detach the connections.
Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled C.
Hold the No. 1 air cleaner inlet by the protrusions labeled D and labeled E, and detach the connections.
Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled F.
REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for AWD)
for 2WD:
Remove the 2 screws and front wheel opening extension pad LH.
for AWD:
Remove the 5 screws and front wheel opening extension pad LH.
*A | for 2WD | *B | for AWD |
REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for AWD)
Tech Tips
Use the same procedure described for the LH side.
REMOVE NO. 1 ENGINE UNDER COVER
*A | for 2WD |
*B | for AWD |
Remove the 13 screws, 7 clips and No. 1 engine under cover.
DRAIN ENGINE COOLANT
CAUTION:
Do not remove the radiator reservoir cap and vent plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the radiator drain cock plug.
*1 | Radiator Drain Cock Plug | *2 | Radiator Reservoir Cap |
*3 | Vent Plug | *4 | Cylinder Block Drain Cock Plug |
Tech Tips
Collect the coolant in a container and dispose of it according to the regulations in your area.
*1 | Vent Plug |
Remove the radiator reservoir cap, and using a 6 mm hexagon wrench, remove the vent plug.
Drain coolant.
Loosen the 2 cylinder block drain cock plugs.
REMOVE INTAKE AIR CONNECTOR PIPE
Disconnect the No. 1 and No. 2 ventilation hoses from the intake air connector pipe.
*a | w/ Intake Air Sound Creator | *b | w/ Intake Air Resonator |
Using a clip remover, detach the 2 wire harness clamps.
Loosen the 3 hose clamps, and remove the intake air connector pipe.
Remove the intake air sound creator.
Tech Tips
Only perform this procedure when replacement of the intake air sound creator is necessary.
Loosen the hose clamp and remove the intake air sound creator.
REMOVE THROTTLE BODY ASSEMBLY
Disconnect the throttle motor connector.
Remove the 4 bolts and throttle body assembly.
Disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body assembly.
Remove the gasket from the intake manifold.