Note
Initialize the headlight leveling ECU assembly (set the zero point of the height control sensor in the headlight leveling ECU assembly) after the vehicle height changes due to replacement of the suspension or after performing such operations as removal and reinstallation or replacement of the rear height control sensor sub-assembly RH.
When the headlight leveling ECU assembly is replaced, initialization is also necessary.
Adjust the headlight aim after initializing the headlight leveling ECU assembly Click here.
When a malfunction is detected in the automatic headlight beam level control system, height control sensor signal initialization is impossible. Perform troubleshooting before initialization.
PREPARE VEHICLE FOR INITIALIZATION
Unload the vehicle and its trunk, ensuring that the spare tire, tools and jack are in their original positions.
Check that there are no occupants in the vehicle.
Turn off the headlights.
Stop the vehicle on a level surface and keep the vehicle height unchanged.
NEXT |
CHECK HEADLIGHT BEAM LEVEL CONTROL INDICATOR LIGHT
Turn the power switch on (IG), and check the indicator light.
OK | ||||||
---|---|---|---|---|---|---|
|
Tech Tips
If the indicator light does not come on when turning the power switch on (IG), inspect and repair it according to Problem Symptoms Table Click here.
NG |
GO TO PROBLEM SYMPTOMS TABLE |
OK |
INITIALIZATION
Connect terminals 4 (CG) and 8 (LVL) of the DLC3 using SST.
Turn the low beam headlights on and off using the light control switch within 20 seconds after connecting the terminals.
Tech Tips
The number of times the low beam headlights need to be turned on and off is determined by the present fuel level as shown below.
Fuel Level | Number of Times to Turn Low Beam Headlights on and off |
---|---|
Fuel level is within A range. | 1 |
Fuel level is within B range. | 2 |
Fuel level is within C range. | 3 |
Fuel level is within D range. | 4 |
Fuel level is within E range. | 5 |
Note
Turn the low beam headlights on and off at less than 3-second intervals.
Be sure to operate the light control switch from outside the vehicle.
Check the indicator light.
OK | ||||||
---|---|---|---|---|---|---|
|
Tech Tips
*1: The number of times that the indicator blinks is determined by the number of times the low beam headlights are turned on and off.
If initialization cannot be finished normally, disconnect SST from the DLC3 and turn the power switch off. Then, restart from procedure 1.
NG |
GO TO PROBLEM SYMPTOMS TABLE |
OK |
TURN POWER SWITCH OFF (END) |