Note
If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.
PRECAUTION (w/ Navigation System for HDD)
Note
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 9 clips and cool air intake duct seal.
REMOVE INLET NO. 2 AIR CLEANER
Disconnect the 2 wire harness clamps and vacuum hose clamp.
Remove the 2 bolts and inlet No. 2 air cleaner.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter connector and wire harness clamp.
Disconnect the 3 hoses.
Separate the ventilation hose.
Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.
Release the 2 clamps and remove the air cleaner cap with hose.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.
Remove the 2 bolts and air cleaner case sub-assembly.
REMOVE BATTERY
Disconnect the positive (+) cable from the positive (+) battery terminal.
Loosen the nut and remove the bolt.
Remove the battery and battery tray.
REMOVE INLET NO. 1 AIR CLEANER
Disengage the pin and remove the inlet No. 1 air cleaner.
REMOVE TCM
Turn the lock lever and disconnect the connector from the TCM.
Remove the 2 bolts and TCM from the automatic transaxle assembly.