HEIGHT CONTROL COMPRESSOR REMOVAL

Note

Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR WHEEL LH

  3. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH

    A00995C

    1. Remove the 2 clips and 5 screws.

    2. Remove the rear quarter panel mudguard.

  4. REMOVE HEIGHT CONTROL COMPRESSOR COVER


    1. Remove the 3 clips and height control compressor cover.

  5. REMOVE REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)

    A009BRGE01
    Text in Illustration
    *1 Guide

    1. Remove the screw.

    2. Detach the guide and remove the rear bumper protector.

  6. REMOVE HEIGHT CONTROL FILTER


    1. Slide the 2 clips and disconnect the 2 hoses.

    2. A00JWZC

      Remove the 2 bolts and height control filter from the height control compressor bracket.

  7. DISCONNECT NO. 2 HEIGHT CONTROL TUBE


    1. A00JW1K

      Disconnect the No. 2 height control tube from the No. 2 height control valve Click here.

      Tech Tips

      For the disconnection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.

  8. REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY


    1. A00JXXI

      Disconnect the connector.

    2. Detach the 3 clamps.

    3. Detach the No. 2 height control tube.

    4. A00JTWA

      Disconnect the connector.

    5. Detach the clamp.

    6. A00JVNS

      Remove the 3 bolts and height control compressor.

    7. A00K1FQ

      Remove the bolt and height control dryer.

    8. Remove the O-ring.

    9. A00JYJO

      Remove the 3 bushes from the height control compressor.

  9. REMOVE HEIGHT CONTROL COMPRESSOR BRACKET


    1. A00JU6E

      Remove the 3 bolts and height control compressor bracket.