DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Enter the following menus: Body Electrical / MAIN BODY / Data List.
Read the Data List according to the display on the tester.
Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
---|---|---|---|
Wireless Control | Wireless door lock control function / ON or OFF | ON: Operating OFF: Not operating |
- |
Hazard Answer Back | Hazard answer-back of wireless / ON or OFF | ON: Operating OFF: Not operating |
- |
Open Door Warning*1 |
Open door warning / ON or OFF | ON: Operating OFF: Not operating |
- |
Unlock 2 Operation*1 |
Unlock 2 Operation of wireless unlock / ON or OFF | ON: All doors unlock when UNLOCK switch pressed twice OFF: All doors unlock when UNLOCK switch pressed once |
- |
Panic Function*1 |
Panic function / ON or OFF | ON: Operating OFF: Not operating |
- |
Auto Lock Time | Automatic lock time / 120 s, 60 s or 30 s | 120 s: 120 seconds 60 s: 60 seconds 30 s: 30 seconds |
- |
Wireless Buzzer Resp*1 |
Wireless door lock buzzer response / ON or OFF | ON: Operating OFF: Not operating |
- |
Wireless Glass Hatch Open*2 |
Glass hatch open function type / 1tim ON, 1tim ON, Long 1, Long 2 or Prohibit | 1tim ON: Push once 2tim ON: Push twice Long 1: Push and hold for 0.6 seconds Long 2: Push and hold for 0.8 seconds Prohibit: Does not operate |
- |
Tech Tips
*1: for RHD
*2: w/ Glass Hatch Opener System
ACTIVE TEST
Tech Tips
Using the intelligent tester to perform Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Test early in troubleshooting is one way to save diagnostic time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON position.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the tester.
Tester Display | Test Part | Control Range | Diagnostic Note |
---|---|---|---|
Hazard | Turns the turn signal flasher relay | ON/OFF | Observe headlight and rear combination light for correct operation |
Vehicle Horn | Turns the vehicle horns | ON/OFF | - |
Illuminated Entry System | Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed) | ON/OFF | - |
Trunk and Back-Door Open | Turns the back door opener motor | ON/OFF | Observe back door |
Wireless Buzzer* |
Wireless door lock buzzer | ON/OFF | - |
Tech Tips
*: for RHD