DESCRIPTION
This circuit opens and closes the Intake Air Control Valve (IACV) in response to the engine load in order to increase the intake efficiency (ACIS: Acoustic Control Induction System).
*1 | Intake Air Control Valve Open | *2 | Intake Air Control Valve Close |
WIRING DIAGRAM
INSPECTION PROCEDURE
Note
Inspect the fuses of circuits related to this system before performing the following inspection procedure.
PROCEDURE
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE VSV FOR ACIS)
Disconnect the vacuum hose from port F on the vacuum switching valve (for ACIS).
Connect the intelligent tester to the DLC3.
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.
Operate the VSV for ACIS.
Check the VSV air flow when switching the VSV on and off.
OK | ||||||
---|---|---|---|---|---|---|
|
NG |
INSPECT VSV FOR ACIS Click here |
OK |
CHECK VACUUM HOSES (VACUUM SWITCHING VALVE - INTAKE AIR CONTROL VALVE, INTAKE MANIFOLD)
Check the vacuum hoses Click here.
NG |
REPAIR OR REPLACE VACUUM HOSES |
OK |
INSPECT INTAKE MANIFOLD (INTAKE AIR CONTROL VALVE)
Inspect the intake air control valve Click here.
NG |
REPLACE INTAKE MANIFOLD Click here |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here
INSPECT VSV FOR ACIS
Inspect the VSV for ACIS Click here.
NG |
REPLACE VSV FOR ACIS Click here |
OK |
CHECK HARNESS AND CONNECTOR (VACUUM SWITCHING VALVE - ECM AND INTEGRATION RELAY)
*1 | Front view of wire harness connector (to VSV for ACIS) |
*2 | Front view of wire harness connector (to ECM) |
*3 | Front view of wire harness connector (to Integration Relay) |
Disconnect the VSV for ACIS connector.
Disconnect the ECM connector.
Remove the integration relay from the engine room relay block.
Disconnect the integration relay connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for open) | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Standard Resistance (Check for short) | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Reconnect the VSV for ACIS connector.
Reconnect the ECM connector.
Reconnect the integration relay connector.
Install the integration relay.
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (VSV FOR ACIS - ECM AND INTEGRATION RELAY) |
OK |
CHECK ECM POWER SOURCE CIRCUIT
Check the ECM power source circuit Click here.
NG |
REPAIR ECM POWER SOURCE CIRCUIT |
OK |
REPLACE ECM Click here