DESCRIPTION
If some ECUs and sensors are not displayed on the "Communication Bus Check" screen of the intelligent tester and some ECUs and sensors repeatedly appear and disappear from the screen when the CAN main bus wires are normal (there is no open, short, short to B+ or short to GND in the main bus wires), there may be an open circuit in either of the CAN branch wires.
Tech Tips
If some ECUs and sensors repeatedly appear and disappear from the "Communication Bus Check" screen, communication between the normal ECUs (sensors) and the intelligent tester may be affected by the incomplete signals that are output from the ECU that has an open circuit in either of its CAN branch wires. In this case, the CAN branch wires for the ECUs and sensors that repeatedly appear and disappear from the screen are normal and the ECU that is not displayed on the screen may be the main cause of the problem (this ECU may have an open circuit in either of its CAN branch wires).
Symptom | Trouble Area |
---|---|
2 or more ECUs and/or sensors do not appear on the intelligent tester "Communication Bus Check" screen. | One side of CAN branch wire is open, or output signals are incomplete.
|
*1: w/ Navigation system
*2: w/ Audio and visual system (w/ Multi-display)
INSPECTION PROCEDURE
Tech Tips
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
PROCEDURE
CHECK FOR OPEN IN ONE SIDE OF CAN NO. 1 BUS BRANCH WIRE
Confirm the systems (ECUs and sensors), which use CAN communication, equipped on the vehicle Click here.
Using the intelligent tester, select and perform "Communication Bus Check" Click here.
Observe the screen for approximately 1 minute to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.
Check that the ECUs and sensors, which are connected to the ECUs or sensors that are not displayed on the screen.
Check that the ECUs and sensors, which repeatedly appeared and disappeared from the "Communication Bus Check" screen, are constantly displayed.
NEXT |
GO TO CORRESPONDING COMMUNICATION STOP MODE Click here