DESCRIPTION
The turning on and off of the door mirror foot lights is controlled by the main body LH based on various signals received through BEAN communication.
The main body ECU LH includes a MOS-FET (Metal Oxide Semiconductor - Field Effect Transistor) circuit that fades the door mirror foot lights in and out by duty control.
This MOS-FET circuit has an overheat protection function as a fail-safe. If the main body ECU LH becomes excessively hot, the door mirror foot lights turn off and remain off.
Normal operation will resume when the conditions required to turn on the door mirror foot lights are met again.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body No. 3 / Active Test.
Check the operation.
Tester Display | Test Part | Control Range | Diagnostic Note |
---|---|---|---|
Exterior Foot Light Operation | Door mirror foot lights | ON/OFF | - |
OK |
---|
Door mirror foot lights come on. |
Tech Tips
The door mirror foot lights RH and LH share the same power source. If either of the lights does not come on, there may be a problem in the part of the circuit that relates to that light. Therefore, inspect that part of the circuit.
NG |
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU LH - BATTERY) Click here |
OK |
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU LH - BATTERY)
Disconnect the Q1 main body ECU LH connector.
Measure the voltage according to the value(s) in the table.
Standard Voltage | ||||||
---|---|---|---|---|---|---|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
OK |
REPLACE MAIN BODY ECU LH (COWL SIDE JUNCTION BLOCK LH)