DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE COOL AIR INTAKE DUCT SEAL
Using a clip remover, remove the 9 clips and cool air intake duct seal.
REMOVE RADIATOR GRILLE PROTECTOR
Remove the 2 radiator grille protectors.
REMOVE FRONT BUMPER ASSEMBLY
Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.
Tech Tips
Tape the screwdriver tip before use.
Use the same procedure for the RH side and LH side.
remove the screw.
Tech Tips
Use the same procedure for the RH side and LH side.
Put protective tape around the front bumper assembly.
Remove the 8 screws.
Using a clip remover, remove the 2 clips and screw.
Disengage the 10 claws and disconnect the front bumper assembly as shown in the illustration.
w/ LEXUS Parking Assist-Sensor system:
Disconnect the ultrasonic sensor connector.
Disconnect the headlight cleaner hose.
Note
Prepare a drain pan or a piece of cloth in case washer fluid leaks.
Disconnect the 2 fog light connectors and remove the front bumper assembly.
REMOVE ENGINE ROOM SIDE COVER LH (for LH Side)
for LHD Click here
for RHD Click here
REMOVE ENGINE ROOM SIDE COVER RH (for RH Side)
for LHD Click here
for RHD Click here
REMOVE FRONT UPPER FENDER PROTECTOR
Separate the clip on the rubber portion of the cowl top ventilator louver sub-assembly from the front upper fender protector LH.
Disengage the 4 clips and the claw to remove the front upper fender protector LH.
REMOVE HEADLIGHT ASSEMBLY
Disconnect the connector as shown in the illustration.
Remove the 3 bolts.
Disengage the headlight bracket pin and remove the headlight assembly.