REMOVE FRONT PANEL GARNISH LH
Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.
REMOVE FRONT PANEL GARNISH RH
Disengage the 3 clips and 8 guides to remove the front panel garnish RH.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.
Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.
REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 4 clips as shown in the illustration.
Disconnect the connector to remove the No. 2 instrument panel register assembly.
REMOVE FRONT CONSOLE UPPER PANEL GARNISH
for Blank Type:
Disengage the 2 claws and remove the front console upper panel garnish as shown in the illustration.
for 3 Switch Hole Type:
Disengage the 2 claws as shown in the illustration.
Disconnect each connector to remove the front console upper panel garnish.
REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
*a | Protective Tape |
Apply protective tape to the area shown in the illustration.
Remove the 4 bolts.
Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 6 clips.
Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.
REMOVE NO. 1 RADIO BRACKET
w/o Navigation System:
Remove the 4 screws and No. 1 radio bracket.
w/ Navigation System:
Remove the 6 screws and No. 1 radio bracket.
REMOVE NO. 2 RADIO BRACKET
w/o Navigation System:
Remove the 4 screws and No. 2 radio bracket.
w/ Navigation System:
Remove the 6 screws and No. 2 radio bracket.
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Disengage the 4 clips and remove the air conditioning control assembly.
REMOVE NAVIGATION COMPUTER ASSEMBLY WITH WIRE (w/ Navigation System)
Disconnect the connector.
Disconnect the 2 connectors to remove the navigation computer with wire.
REMOVE RADIO RECEIVER ASSEMBLY (for Radio Receiver Type)
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)