ECM REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.
  2. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01NFNX

      Remove the 4 clips and engine room side cover LH.

  5. REMOVE ENGINE ROOM SIDE COVER


    1. A01NGSF

      Remove the 4 clips and engine room side cover.

  6. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01NCUN

      Remove the 6 clips and cool air intake duct seal.

  7. REMOVE ECM


    1. A01NDZ3

      Separate the 2 wire harness clamps.

    2. Disconnect the 2 ECM connectors and remove the ECM with brackets.


      1. A01NDI7

        Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

      2. A01NEPX

        Remove the bolt and separate the cooler pipe.

      3. A01NEH4

        Remove the 3 bolts and ECM with bracket.

        Note

        Do not deform the cooler pipe when moving it to access the bolts below.

    3. A01NESE

      Remove the 2 bolts and the wire harness bracket.

    4. A01NH16

      Remove the 4 bolts, and remove the No. 1 ECM bracket and No. 2 ECM bracket.

    5. A01ND20

      Unlock the 3 claws, and remove the engine room ECM cover and ECM.