INSTALL REAR ENGINE MOUNTING BRACKET
Install the rear engine mounting bracket with the 5 bolts.
INSTALL FRONT ENGINE MOUNTING BRACKET
Install the front engine mounting bracket with the 3 bolts.
INSTALL ENGINE MOUNTING BRACKET LH
Install the engine mounting bracket LH with the 4 bolts.
INSTALL MANUAL TRANSAXLE ASSEMBLY
Align the input shaft with the clutch disc and install the transaxle to the engine.
Note
Make sure that the dowel pins are not loose, bent, damaged or scratched and then install the transaxle to the engine with the contact surfaces of the engine and transaxle flat against each other.
Install the 5 bolts.
Note
Make sure that the dowel pins are fully engaged, and make sure that the contact surface of the transaxle fits close against the engine assembly before tightening the bolts.
INSTALL STIFFENER PLATE RH
Install the stiffener plate RH with the 4 bolts.
INSTALL STIFFENER PLATE LH
Install the stiffener plate LH with the 4 bolts.
INSTALL OIL PAN INSULATOR
Install the oil pan insulator with the 2 bolts.
INSTALL ENGINE WIRE
Connect the back-up light switch connector, install the 2 bolts, and attach the 3 clamps to install the engine wire to the manual transaxle.
INSTALL AIR TUBE SUPPORT
Install the air tube support with the 2 bolts.
INSTALL STARTER ASSEMBLY
Install the starter assembly with the 2 bolts.
Connect the starter wire with the nut and close the terminal cap.
Connect the starter connector.
INSTALL NO. 1 AIR TUBE
Установите воздушный патрубок № 1, закрепив его 2 болтами, и затяните хомут.
Note
Прежде чем производить установку, полностью удалите остатки масла с внутренних поверхностей патрубка и шланга.
INSTALL REAR ENGINE MOUNTING INSULATOR
Установите заднюю подушку опоры двигателя и закрепите ее 2 болтами и 2 гайками.
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
Install the engine assembly with transaxle Click here.