SKID CONTROL ECU REMOVAL

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/close the doors while the battery is connected.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (for RHD)

    Tech Tips

    Refer to the procedure up to Remove Driver Side Knee Airbag Assembly Click here.

  3. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (for LHD)

    Tech Tips

    Refer to the procedure up to Remove Front Passenger Side Knee Airbag Assembly Click here.

  4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    1. A01NFHC

      Remove the 5 screws <F>.

    2. A01NGIS

      Disengage the claw, 4 clips and guide.

    3. Disconnect each connector and remove the glove compartment door assembly.

  5. SEPARATE CONNECTOR HOLDER (for RHD)


    1. A01NET0

      Remove the 2 nuts and separate the connector holder.

  6. REMOVE SKID CONTROL ECU (for RHD)


    1. A01NG4S

      Remove the 2 bolts and skid control ECU.

    2. A01NGNX

      Disconnect the 4 connectors from the skid control ECU.

  7. SEPARATE ECU INTEGRATION BOX RH (for LHD)


    1. A01ND00

      Remove the 2 nuts and bolt, separate the ECU integration box RH.

  8. SEPARATE CONNECTOR HOLDER (for LHD)


    1. Remove the nut and separate the connector holder.

  9. REMOVE SKID CONTROL ECU (for LHD)


    1. A01NDFA

      Remove the 2 bolts and skid control ECU.

    2. Disconnect the 4 connectors from the skid control ECU.