SFI SYSTEM (w/o Secondary Air Injection System) DTC CHECK / CLEAR

Note

Intelligent tester only:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode will be erased. Before changing modes, always check and make a note of DTCs and freeze frame data.

A01J639E01

  1. CHECK DTC (using intelligent tester)

    A01J7NIE01

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON and turn the intelligent tester ON.

    3. A01J6I3E01

      Enter the following menus: Powertrain / Engine and ECT / DTC.

    4. Check and make a note of DTCs and freeze frame data.

      Tech Tips

      For information on using the intelligent tester, refer to the instruction manual.

    5. Confirm the details of the DTCs Click here.

  2. CHECK DTC (not using intelligent tester)


    1. Turn the ignition switch ON.

    2. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040
    3. A01J4ULE01

      Read DTCs by observing the MIL. If any DTC is not detected, the MIL blinks as shown in the illustration.

    4. A01J4OTE04

      Example


      1. DTCs 12 and 31 are detected and the MIL starts displaying the DTCs, as shown in the illustration. The MIL blinking pattern of DTC 12 will be displayed first.

      2. A 2.5 seconds pause will occur. This pause will occur between the MIL blinking patterns of each DTC.

      3. The MIL blinking pattern of DTC 31 will be displayed.

      4. A 4.5 seconds pause will occur. This pause will occur when the MIL blinking pattern is the last of a string of multiple DTCs.

      5. The MIL will repeat the display of the string of DTCs.

    5. Check the details of the malfunction using the DTC chart Click here.

    6. After completing the check, disconnect terminals 13 (TC) and 4 (CG) and turn off the display.

      Tech Tips

      In the event that 2 or more DTCs are detected, the MIL will indicate the smaller number DTC first.

    7. Confirm the details of the DTCs Click here.

  3. FREEZE FRAME DATA (using intelligent tester)

    A01J75FE03

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON and turn the intelligent tester ON.

    3. Read DTCs by selecting the following menu items: Powertrain / Engine and ECT / DTC.

    4. Select a parameter to check using the freeze frame data.

    5. Note the DTC(s) and freeze frame data.

      Tech Tips

      Refer to the intelligent tester's instruction manual for further details.

  4. CLEAR DTC AND FREEZE FRAME DATA (using intelligent tester)

    A01J4ZXE04

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON (do not start the engine) and turn the intelligent tester ON.

    3. Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

    4. Erase DTCs and freeze frame data by pressing the YES button on the tester.

      Tech Tips

      For information on using the intelligent tester, refer to the instruction manual.

  5. CLEAR DTC AND FREEZE FRAME DATA (not using intelligent tester)


    1. Remove the EFI and ETCS fuses from the engine room relay block and junction block for more than 60 seconds, or disconnect the battery cable for more than 60 seconds.