INSTALL TENSIONER PULLEY
Note
Perform the following procedure when it is necessary to replace the tensioner pulley.
Tech Tips
The tensioner pulley service kit consists of a bolt, dust seal and tensioner pulley.
Install the dust seal and bolt to the tensioner pulley as shown in the illustration.
Note
The dust seal must be oriented correctly when installed. If the dust seal is installed incorrectly, the bearing may be damaged.
Do not touch the seal surface of the bearing.
Tech Tips
Be sure to use the bolt from the service kit.
Tighten the bolt by hand until the flange of the bolt contacts the dust seal and the tensioner pulley is fixed in place.
Note
Do not use any tools.
Tighten the bolt.
Install a new O-ring and the dipstick guide with the bolt.
Install the oil dipstick.
INSTALL DRIVE BELT
Install the drive belt to the pulleys except the drive belt tensioner pulley.
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.
Note
The backside of the drive belt should face the tensioner pulley.
Check that the drive belt is properly set to each pulley.
After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.