CHECK DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body / Charging Control / DTC.
Check the DTC(s).
CLEAR DTC
Note
Do not clear DTCs until the cause of the malfunction is determined.
After inspecting and repairing the charging system and clearing DTCs, be sure to recheck for DTCs and make sure that no DTCs are output.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body / Charging Control / DTC.
Clear the DTC(s).
CLEAR DTC (Without using the intelligent tester)
Note
Do not clear DTCs until the cause of the malfunction is determined.
After inspecting and repairing the charging system and clearing DTCs, be sure to recheck for DTCs and make sure that no DTCs are output.
Perform either one of the following operations:
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the AM2 No. 2 fuse from the engine room No. 1 relay block for more than 1 minute.
Tech Tips
The time of 1 minute specified above is for when the vehicle is at room temperature (25°C (77°F)). If the ambient temperature is low (-30°C (-86°F)), it may be necessary to wait for more than 300 seconds.
When clearing DTCs with the vehicle at a temperature between room temperature (25°C (77°F)) and low temperature (-30°C (-86°F)), it is necessary to wait for at least the amount of time shown in the graph.