DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter the following menus:
Select: Body / (desired system) / Data List /
According to the display on tester, read the "Data List".
Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
---|---|---|---|
Rear Shade Switch | Rear sunshade switch/ON or OFF | ON: Rear sunshade switch is pressed OFF: Rear sunshade switch is not pressed |
- |
Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
---|---|---|---|
Rear Shade Switch | Rear sunshade switch/ON or OFF | ON: Rear sunshade switch is pressed OFF: Rear sunshade switch is not pressed |
- |
Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
---|---|---|---|
Rear Sunshade Close | Status of the rear sunshade close/YES or NO | YES: Rear sunshade limit switch is OFF (Rear sunshade is lowered) NO: Rear sunshade limit switch is ON (Rear sunshade is raised) |
- |
ACTIVE TEST
Tech Tips
Using the intelligent tester to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Note
When a Body No. 4 (luggage room junction block) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter the following menus:
Select: Body / Body No. 4 / Active Test /
According to the display on tester, perform the "Active Test".
Tester Display | Test Part | Control Range | Diagnostic Note |
---|---|---|---|
Rear Sunshade Operation | Rear Sunshade Operation | Down, No or Up | - |