INSTALL STEERING PAD
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Connect the 2 airbag connectors to the steering pad.
Note
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to only connect the connectors to each corresponding color.
Push in the 2 locks to install the 2 airbag connectors.
Connect the horn connector to the steering pad.
Push the horn button assembly to attach the 3 pins carefully.
Note
Make sure that the pins are securely inserted into the steering holes.
Make sure to engage the 2 upper pins first.
Make sure that the horn button assembly is securely installed.
INSTALL LOWER NO. 3 STEERING WHEEL COVER
Attach the claw to install the lower No. 3 steering wheel cover.
INSTALL LOWER NO. 2 STEERING WHEEL COVER
Attach the claw to install the lower No. 2 steering wheel cover.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT STEERING PAD
Make sure that the horn sounds.
Tech Tips
If the horn does not sound, inspect the horn system Click here.
PERFORM DIAGNOSTIC SYSTEM CHECK
INSPECT SRS WARNING LIGHT