DTC Code | DTC Name |
---|---|
P2111 | Throttle Actuator Control System - Stuck Open |
P2112 | Throttle Actuator Control System - Stuck Closed |
SYSTEM DESCRIPTION
The throttle actuator is operated by the ECM, and opens and closes the throttle valve using gears. The opening angle of the throttle valve is detected by the throttle position sensor, which is mounted on the throttle body with motor assembly. The throttle position sensor provides feedback to the ECM. This feedback allows the ECM to appropriately control the throttle actuator and monitor the throttle opening angle as the ECM responds to driver inputs.
Tech Tips
This ETCS (Electronic Throttle Control System) does not use a throttle cable.
DTC No. | DTC Detection Condition | Trouble Area |
---|---|---|
P2111 | The ECM signals the throttle actuator to close, but the valve is stuck (1 trip detection logic). |
|
P2112 | The ECM signals the throttle actuator to open, but the valve is stuck (1 trip detection logic). |
|
MONITOR DESCRIPTION
The ECM determines that there is a malfunction in the ETCS when the throttle valve remains at a fixed angle despite a high drive current from the ECM. The ECM illuminates the MIL and stores a DTC.
If the malfunction is not repaired successfully, a DTC is stored when the accelerator pedal is fully depressed and released quickly (to fully open and close the throttle valve) after the engine is next started.
FAIL-SAFE
When either of these DTCs as well as other DTCs relating to ETCS (Electronic Throttle Control System) malfunctions are stored, the ECM enters fail-safe mode. During fail-safe mode, the ECM cuts the current to the throttle actuator, and the throttle valve is returned to a 7° throttle angle by the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal opening angle to allow the vehicle to continue running at a minimal speed. If the accelerator pedal is depressed firmly and gently, the vehicle can be driven slowly.
The ECM continues operating in fail-safe mode until a pass condition is detected, and the ignition switch is then turned off.
WIRING DIAGRAM
Refer to DTC P2102 Click here.
INSPECTION PROCEDURE
Tech Tips
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
PROCEDURE
INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (VISUALLY CHECK THROTTLE VALVE)
Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body with motor assembly. Also check that the throttle valve moves smoothly.
OK |
---|
Throttle valve is not contaminated with foreign objects and moves smoothly. |
NG |
REPLACE THROTTLE BODY WITH MOTOR ASSEMBLY Click here |
OK |
CHECK WHETHER DTC OUTPUT RECURS (DTC P2111 OR P2112)
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs Click here.
Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
Result | Proceed to |
---|---|
No DTC output | A |
P2111 or P2112 is output | B |
B |
REPLACE ECM Click here |
A |
CHECK FOR INTERMITTENT PROBLEMS Click here