Note
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.
Tech Tips
DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display the current, pending and permanent DTCs.
Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.
CHECK DTC
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the Trouble Codes Click here.
CLEAR DTC (Using the GTS)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Clear the DTCs.
CLEAR DTC (Without using the GTS)
Perform either of the following operations:
Note
After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI NO. 1 and ETCS fuses from the engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.