Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PRECAUTION (w/ Air Suspension)
Note
Be sure to read Precaution thoroughly before servicing Click here.
REMOVE REAR WHEEL
DRAIN BRAKE FLUID
Note
If brake fluid leaks onto any painted surface, immediately wash it off.
DISCONNECT REAR FLEXIBLE HOSE
Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.
REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
*1 | Hold |
*2 | Turn |
Hold the 2 rear disc brake cylinder slide pins, and remove the 2 bolts and rear disc brake cylinder assembly.
REMOVE REAR DISC BRAKE PAD
Remove the 2 rear disc brake pads from rear disc brake cylinder mounting.
REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM
Remove the 2 rear disc brake anti-squeal shims from the rear disc brake pads.
REMOVE PAD WEAR INDICATOR PLATE
Using a screwdriver, remove 2 pad wear indicator plates from the rear disc brake pads as shown in the illustration.
REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
for Solid Type Rear Disc | for Ventilated Type Rear Disc | |
---|---|---|
*1 | No. 1 Rear Disc Brake Pad Support Plate | No. 1 Rear Disc Brake Pad Support Plate |
*2 | No. 2 Rear Disc Brake Pad Support Plate | No. 2 Rear Disc Brake Pad Support Plate |
*3 | No. 1 Rear Disc Brake Pad Support Plate | No. 1 Rear Disc Brake Pad Support Plate with Tape |
*4 | No. 2 Rear Disc Brake Pad Support Plate | No. 2 Rear Disc Brake Pad Support Plate with Tape |
Remove the 2 No. 1 rear disc brake pad support plates and 2 No. 2 rear disc brake pad support plates from the rear disc brake cylinder mounting.
Note
The No. 1 rear disc brake pad support plate and the No. 2 rear disc brake pad support plate have different shape. Be sure to put an identification mark on each rear disc brake pad support plate so that they can be reinstalled to their original position.
REMOVE NO. 1 REAR DISC BRAKE CYLINDER SLIDE PIN
Remove the No. 1 rear disc brake cylinder slide pin from the rear disc brake cylinder mounting.
REMOVE NO. 2 REAR DISC BRAKE CYLINDER SLIDE PIN
Remove the No. 2 rear disc brake cylinder slide pin from the rear disc brake cylinder mounting.
REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSHING
*1 | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake cylinder slide bushing from the No. 1 rear disc brake cylinder slide pin.
Note
Do not damage the No. 1 rear disc brake cylinder slide pin.
REMOVE REAR DISC BRAKE BUSHING DUST BOOT
Remove the 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting.
REMOVE REAR DISC BRAKE CYLINDER MOUNTING
Remove the 2 bolts and rear disc brake cylinder mounting from the rear axle carrier sub-assembly.
REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Remove the parking brake shoe adjusting hole plug.
REMOVE REAR DISC
*1 | Matchmark |
Put matchmarks on the rear disc and the axle hub.
Release the parking brake and remove the rear disc.
Tech Tips
If the disc can not be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.