DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:U0100, U0125, U0126, U0129

DTC Code DTC Name
U0100 Lost Communication with ECM / PCM "A"
U0125 Lost Communication with Yaw Rate Sensor Module
U0126 Lost Communication with Steering Angle Sensor Module
U0129 Lost Communication with Brake System Control Module

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle. Based on this information, the driving support ECU assembly sends pre-crash safety control operation signals. These DTCs are stored when a communication malfunction occurs between the sensors and ECUs that detect crashes, or between ECUs that perform the pre-crash safety control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When the engine switch is on (IG), a communication error between the ECM and the driving support ECU assembly is detected for approximately 1 second.

  • CAN communication system

  • ECM

  • Driving support ECU assembly
U0125 Lost Communication with Yaw Rate Sensor Module When the engine switch is on (IG), a communication error between the airbag ECU assembly and the driving support ECU assembly is detected for approximately 1 second.

  • CAN communication system

  • Airbag ECU assembly

  • Driving support ECU assembly
U0126 Lost Communication with Steering Angle Sensor Module When the engine switch is on (IG), a communication error between the spiral with sensor cable sub-assembly (steering angle sensor) and the driving support ECU assembly is detected for approximately 1 second.

  • CAN communication system

  • Spiral with sensor cable sub-assembly

  • Driving support ECU assembly
U0129 Lost Communication with Brake System Control Module When the engine switch is on (IG), a communication error between the brake actuator assembly (skid control ECU) and the driving support ECU assembly is detected for approximately 3 seconds.

  • CAN communication system

  • Brake actuator assembly (skid control ECU)

  • Driving support ECU assembly

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      Powertrain > Radar Cruise > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check the DTCs.

      Click here


      Powertrain > Radar Cruise > Trouble Codes
      Result
      Result Proceed to
      DTC U0100, U0125, U0126 and U0129 are not output A
      DTC U0100, U0125, U0126 or U0129 is not output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    GO TO CAN COMMUNICATION SYSTEM for RHD: Click here
    GO TO CAN COMMUNICATION SYSTEM for LHD: Click here