ROAD SIGN ASSIST SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Road Sign Assist / Data List.

    5. Read the Data List according to the display on the GTS.

      Body Electrical > Road Sign Assist > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      RSA Fusion Control

      RSA fusion control operation status

      OFF or ON

      OFF: Not operating

      ON: Operating

      -

      Traffic Sign Speed Unit

      Unit of speed of traffic sign

      kph or mph

      kph: km/h

      mph: mph

      -

      Estimated Traffic Division

      Detected direction of traffic stored in the forward recognition camera

      Unconfirmed, Right-hand traffic or Left-hand traffic

      Unconfirmed: Unconfirmed

      Right-hand traffic: Right-hand traffic

      Left-hand traffic: Left-hand traffic

      -