ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV), Diagnostic DTC:P0756

DTC Code DTC Name
P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2)

DESCRIPTION

The TCM uses signals from the vehicle speed sensor and direct clutch speed sensor to detect the actual gear position (1st, 2nd, 3rd or 4th gear).

Then the TCM compares the actual gear with the shift schedule in the TCM memory to detect mechanical problems of the shift solenoid valves, valve body or automatic transmission (clutch, brake or gear, etc.).

DTC No. DTC Detection Condition Trouble Area
P0756 The gear required by the TCM does not match the actual gear when driving (2-trip detection logic)

  • Shift solenoid valve S2 remains open or closed

  • Valve body is blocked

  • Automatic transmission (clutch, brake or gear, etc.)

MONITOR DESCRIPTION

This DTC indicates "stuck ON malfunction" or "stuck OFF malfunction" of the shift solenoid valve S2.

The TCM commands gear shifts by turning the shift solenoid valves "ON/OFF". When the gear position commanded by the TCM and the actual gear position are not the same, the TCM illuminates the MIL and stores the DTC.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK DTC OUTPUT (IN ADDITION TO DTC P0756)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON and push the intelligent tester main switch ON.

    3. Enter the following menus: Powertrain / ECT / DTC / Current or Pending.

    4. Read the DTCs using the intelligent tester.

      Result
      Display (DTC output) Proceed to
      Only P0756 is output A
      P0756 and other DTCs are output B

      Tech Tips

      If any other codes besides P0756 are output, perform troubleshooting for those DTCs first.


    B

    GO TO DTC CHART

    A

  2. INSPECT SHIFT SOLENOID VALVE S2


    1. A01DVXLE03

      Remove the shift solenoid valve S2.

    2. Measure the resistance of the solenoid value.

      Standard resistance
      Tester Connection Condition Specified Condition
      Shift solenoid S2 connector - Shift solenoid S2 body 20°C (68°F) 11 to 15 Ω

    3. Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

    4. Check the operating noise of the solenoid valve.

      OK
      Solenoid makes operating noise.

    NG

    REPLACE SHIFT SOLENOID VALVE S2

    OK

  3. INSPECT TRANSMISSION VALVE BODY ASSEMBLY


    1. Check the transmission valve body assembly.

      OK
      There are no foreign objects on each valve.

    NG

    REPAIR OR REPLACE TRANSMISSION VALVE BODY ASSEMBLY

    OK

    REPAIR OR REPLACE AUTOMATIC TRANSMISSION ASSEMBLY