MASS AIR FLOW METER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during mass air flow meter sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Mass air flow meter sub-assembly Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE RADIATOR COVER PLATE

    Click here

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. REMOVE MASS AIR FLOW METER SUB-ASSEMBLY


    1. B006F4SC01
      *A for Bank 1
      *B for Bank 2

      Disconnect the 2 mass air flow meter sub-assembly connectors.

    2. Remove the 4 screws and 2 mass air flow meter sub-assemblies.

      Note

      If the mass air flow meter sub-assembly has been struck or dropped, replace it.