FRONT DOOR LOCK(for Sedan) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick here

  3. REMOVE DOOR ASSIST GRIP COVER

    Click here

  4. REMOVE FRONT ARMREST ASSEMBLY

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR GLASS RUN

    Click here

  12. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  13. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  14. REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY

    1. B350934C01

      *1

      Front Door Lock Open Rod

      Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Slide the front door lock with motor assembly downward, to disconnect the front door lock open rod and remove the front door lock with motor assembly and cables as a unit.

    4. When reusing the front door lock with motor assembly:

      1. B350936

        Remove the door lock wiring harness seal from the front door lock with motor assembly.

  15. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  16. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here