MULTI-MODE MANUAL TRANSAXLE SYSTEM Pattern Select Switch Circuit

DTC Code DTC Name
Pattern Select Switch Circuit

DESCRIPTION

While the vehicle is driven with the shift lever in E, the most appropriate gear is automatically selected according to the accelerator pedal opening angle and vehicle speed. During this time, shift control can be switched between easy (E) mode and easy sports (Es) mode by pressing the pattern select switch.

WIRING DIAGRAM

C279540E01

PROCEDURE

  1. INSPECT PATTERN SELECT SWITCH

    1. C278282C01

      *a

      Component without harness connected

      (Pattern Select Switch)

      Remove the pattern select switch.

      Click here

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      11 - 8

      Pattern select switch pressed continuously

      Below 1 Ω

      Pattern select switch released

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    NG

    REPLACE PATTERN SELECT SWITCH

    Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH - BODY GROUND)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E105-8 - Body ground

      Always

      Below 1 Ω

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH - TCM)

    1. Disconnect the TCM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E104-23 (ESSW) - E105-11

      Always

      Below 1 Ω

      E104-23 (ESSW) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. REPLACE TCM

    1. Replace the TCM.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  5. PERFORM INITIALIZATION

    1. Perform the initialization and learning procedure.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

    END