ECM REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. SEPARATE INLET NO. 1 AIR CLEANER

    1. A307233

      Remove the bolt and separate the inlet No. 1 air cleaner.

  7. REMOVE ECM

    1. A287748

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

    2. Disengage the wire harness clamp.

    3. A287750

      Remove the 2 bolts.

    4. Disengage the clamp and remove the ECM.

      Note:

      • If the ECM has been struck or dropped, replace it.

      • After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

  8. REMOVE NO. 1 ECM BRACKET

    1. A287751

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  9. REMOVE NO. 2 ECM BRACKET

    1. A287752

      Remove the 2 screws and No. 2 ECM bracket from the ECM.