ROCKER PANEL MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT REAR WHEEL HOUSE PLATE

    Click here

  2. REMOVE ROCKER PANEL MOULDING ASSEMBLY


    1. Apply protective tape around the rocker panel moulding assembly and door as shown in the illustration.

      A01OD21C01
      B008GB8 Protective Tape - -
    2. A01OC7S

      Remove the 2 screws.

    3. Using a clip remover, remove the clip.

    4. A01OBCE

      Remove the screw.

    5. A01ODU8C01
      B008GB8 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the rocker panel moulding cover.

      Tech Tips

      Use the same procedure for the other rocker panel moulding cover.

    6. A01OACS

      Using a clip remover, remove the 6 clips.

    7. Remove the 2 screws.

    8. A01OD05

      Disengage the 10 clips and remove the rocker panel moulding assembly.

    9. Remove the 10 clips from the rocker panel moulding assembly.