ENTRY LOCK AND UNLOCK SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY

    1. B372567

      Insert the front end of the front door outside handle assembly into the front door outside handle frame.

    2. Insert the rear end of the front door outside handle assembly into the front door outside handle frame, then slide the front door outside handle assembly toward the front of the vehicle to install it.

    3. Connect the connector.

  3. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click hereClick here

  4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Front Passenger Side)

    Click hereClick here

  5. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click hereClick here

  6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click hereClick here

  8. INSTALL FRONT DOOR TRIM COVER

    Click hereClick here

  9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click hereClick here

  10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click hereClick here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  12. INSPECT POWER WINDOW OPERATION

    Click here