ULTRASONIC SENSOR(for Front) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front television camera assembly or front bumper assembly (w/ Panoramic view monitor system) Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration
Replacement of ultrasonic sensor (front left sensor, front left center sensor, front right center sensor, front right sensor) Initialization of ultrasonic sensors (front left sensor, front left center sensor, front right center sensor, front right sensor) LEXUS parking assist-sensor system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 1 ULTRASONIC SENSOR


    1. for Bar Type Radiator Grille:


      1. B007XHA

        Disconnect the connector.

        Tech Tips

        The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

      2. B007ZR7C01
        B007Z37 Remove in this Direction

        Disengage the 2 claws and remove the No. 1 ultrasonic sensor as shown in the illustration.

        Tech Tips

        The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

    2. for Mesh Type Radiator Grille:


      1. B007YPX

        Disconnect the connector.

        Tech Tips

        The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

      2. B007ZQ1C01
        B007Z37 Remove in this Direction

        Disengage the 2 claws and remove the No. 1 ultrasonic sensor as shown in the illustration.

        Tech Tips

        The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  3. REMOVE NO. 2 ULTRASONIC SENSOR


    1. B007WNG

      Disconnect the connector.

      Tech Tips

      The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

    2. B007ZCBC01
      B007Z37 Remove in this Direction

      Disengage the 2 claws and remove the No. 2 ultrasonic sensor as shown in the illustration.

      Tech Tips

      The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  4. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this procedure only when replacement of the No. 2 ultrasonic sensor retainer is necessary.

    • When removing the No. 2 ultrasonic sensor retainer, heat the front bumper assembly and No. 2 ultrasonic sensor retainer using a heat light.


    1. Heat the front bumper assembly and No. 2 ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.

      Heating Temperature
      Item Temperature
      Front Bumper Assembly 40 to 60°C (104 to 140°F)
      No. 2 Ultrasonic Sensor Retainer

      CAUTION:


      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

      B007Y0LC23
      *a Heated Part
      *b Heat Light
    2. B007YOM

      Remove the No. 2 ultrasonic sensor retainer.