ROOF SUNSHADE SWITCH INSPECTION

PROCEDURE

  1. INSPECT ROOF SUNSHADE SWITCH (MAP LIGHT ASSEMBLY)

    1. B319626C01

      *a

      Component without harness connected

      (Roof Sunshade Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      12 (OPN) - 11 (GND)

      Open switch is pressed

      Below 1 Ω

      12 (OPN) - 11 (GND)

      Open switch is not pressed

      10 kΩ or higher

      13 (CLS) - 11 (GND)

      Close switch is pressed

      Below 1 Ω

      13 (CLS) - 11 (GND)

      Close switch is not pressed

      10 kΩ or higher

      If the result is not as specified, replace the roof sunshade switch (map light assembly).