STEERING ANGLE SENSOR INSTALLATION

PROCEDURE

1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

   1. Install the spiral cable with steering angle sensor.

      • for Single Type:

        Click here

      • for Dual Type:

        Click hereClick here

      Note:

      • Do not replace the spiral cable with the battery connected and the power switch on (IG).

      • Do not rotate the spiral cable with the battery connected and the power switch on (IG).

      • Do not remove the steering angle sensor from the spiral cable.

2. INSTALL STEERING COLUMN COVER

   Click here

3. INSTALL STEERING WHEEL ASSEMBLY

   Click here

4. INSTALL STEERING PAD ASSEMBLY

   • for Single Type:

     Click here

   • for Dual Type:

     Click here

5. INSPECT STEERING WHEEL CENTER POINT

6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Click here

7. INSTALL BATTERY SERVICE COVER

   Click here

8. INSTALL DECK BOARD ASSEMBLY

   Click here

9. INSPECT STEERING PAD ASSEMBLY

   • for Single Type

     Click here

   • for Dual Type

     Click here

10. CHECK SRS WARNING LIGHT

    • w/ Occupant Classification System:

      Click here

    • w/o Occupant Classification System:

      Click here