DRIVING SUPPORT SWITCH CONTROL ECU REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereClick hereClick here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Click hereClick here

  3. REMOVE COWL SIDE TRIM BOARD RH

    Click hereClick here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click hereClick here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click hereClick here

  6. REMOVE INSTRUMENT LOWER COVER LH

    Click hereClick here

  7. REMOVE NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY

    Click here

  8. REMOVE INSTRUMENT SIDE PANEL RH

    Click hereClick here

  9. REMOVE INSTRUMENT CENTER CLUSTER FINISH PANEL GARNISH

    Click hereClick here

  10. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click hereClick here

  11. REMOVE INSTRUMENT PANEL BOX DOOR COVER

    Click hereClick here

  12. REMOVE INSTRUMENT PANEL BOX ASSEMBLY

    Click hereClick here

  13. REMOVE DRIVING SUPPORT SWITCH CONTROL ECU

    1. Disconnect the connector.

    2. E197647

      Remove the bolt and driving support switch control ECU.