DIFFERENTIAL PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE

  1. CHECK DIFFERENTIAL PRESSURE SENSOR

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / Adaptation Value of Differential Pressure at Particle Filter.

    5. Disconnect the No. 1 vacuum transmitting hose from the differential pressure sensor.

    6. A341660E01

      Using SST, apply pressure to the differential pressure sensor.

      09992-00242

      Table 1. Text in Illustration
      V100135

      Pressure

    7. Check the pressure value of the differential pressure sensor.

      Standard pressure

      Approximately the same pressure as the applied pressure is indicated on the GTS.

      If the result is not as specified, check the sensor circuit (Click here).

    8. Connect the No. 1 vacuum transmitting hose to the differential pressure sensor.