REAR POWER WINDOW SWITCH INSPECTION

PROCEDURE

  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH DOOR) (for Models with Jam Protection Function on 4 Windows)

    1. B203473C32

      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for LH Door))

      Check the switch function.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        6 (UP) - 1 (GND)

        Auto up or up position

        Below 1 Ω

        7 (DOWN) - 1 (GND)

        Auto down or down position

        Below 1 Ω

        8 (AUTO) - 1 (GND)

        Auto up or auto down position

        Below 1 Ω

        6 (UP) - 1 (GND)

        Off

        10 kΩ or higher

        7 (DOWN) - 1 (GND)

        Off

        10 kΩ or higher

        8 (AUTO) - 1 (GND)

        Off

        10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

    2. B203473C33

      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for LH Door))

      *b

      LED

      Check that the LED illuminates.

      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK

        Measurement Condition

        Specified Condition

        Battery positive (+) → 4 (LED)

        Battery negative (-) → 1 (GND)

        LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

  2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH DOOR) (for Models with Jam Protection Function on 4 Windows)

    1. B203473C32

      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for RH Door))

      Check the switch function.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        6 (UP) - 1 (GND)

        Auto up or up position

        Below 1 Ω

        7 (DOWN) - 1 (GND)

        Auto down or down position

        Below 1 Ω

        8 (AUTO) - 1 (GND)

        Auto up or auto down position

        Below 1 Ω

        6 (UP) - 1 (GND)

        Off

        10 kΩ or higher

        7 (DOWN) - 1 (GND)

        Off

        10 kΩ or higher

        8 (AUTO) - 1 (GND)

        Off

        10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).

    2. B203473C33

      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for RH Door))

      *b

      LED

      Check that the LED illuminates.

      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK

        Measurement Condition

        Specified Condition

        Battery positive (+) → 4 (LED)

        Battery negative (-) → 1 (GND)

        LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).