GENERATOR INSTALLATION

PROCEDURE

  1. INSTALL GENERATOR ASSEMBLY

    1. A355400N01

      Insert the bolt (A) to the generator assembly as shown in the illustration.

    2. A316697C01
      V100135

      Set in this Direction

      Set the generator assembly with bolt (A) to the engine assembly as shown in the illustration.

      Tip:

      As there is not enough clearance to insert the bolt (A) after setting the generator assembly to the engine assembly, set the generator assembly to the engine assembly with the bolt (A) inserted.

    3. A316695N01

      Using an E12 "TORX" socket wrench, tighten the bolt (A) and install the bolt (B).

      38 N*m

      387 kgf*cm

      28 ft.*lbf

    4. Connect the generator assembly connector.

    5. Connect the wire harness to terminal B with the nut.

      12.7 N*m

      130 kgf*cm

      9 ft.*lbf

    6. Install the terminal cap.

  2. INSTALL V-RIBBED BELT

    Click here

  3. INSTALL NO. 1 ENGINE COVER

    Click hereClick hereClick here

  4. INSTALL RADIATOR ASSEMBLY

    Click hereClick here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here