HAZARD WARNING SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE INTEGRATION CONTROL AND PANEL

    Click here

  9. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. A005BD6

      Using a screwdriver, disengage the 4 claws and remove the hazard warning signal switch assembly.