REAR WIPER MOTOR INSTALLATION

PROCEDURE


  1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY


    1. Connect the connector.

    2. Engage the clamp.

    3. Install the rear wiper motor and bracket assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. B005MU9C02
      *a Rear Wiper Motor Grommet Lip

      Apply MP grease to the entire surface of the rear wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. Install the rear wiper motor grommet.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. B005LDTC02
      *a Serration

      When reusing the rear wiper arm and blade assembly:


      1. Clean the wiper arm serrations to remove any burrs, dirt, etc.

        Note

        Do not grind down the wiper arm serrations.

    2. When reusing the rear wiper motor and bracket assembly:


      1. Clean the wiper pivot serrations with a wire brush.

    3. Turn the engine switch on (IG).

    4. Operate the wiper and stop the rear wiper motor and bracket assembly at the automatic stop position.

    5. Turn the engine switch off.

    6. B005OZTC02
      *a Alignment Mark

      Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the rear wiper arm by hand while tightening the nut.

    7. Turn the engine switch on (IG).

    8. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

    9. Turn the engine switch off.

    10. Lift the wiper arm twice after the wiper stops and check the wiper set position.

  4. INSTALL REAR SPOILER SUB-ASSEMBLY

    Click here