EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2) INSTALLATION

PROCEDURE

1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2)

   Note:

   If the exhaust gas temperature sensor is dropped, replace it with a new one.

   1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      30 N*m

      306 kgf*cm

      22 ft.*lbf

      Note:

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

   2. Pass the wire harness through the hook on the cylinder head cover side.

   3. Attach the wire harness clamp.

   4. Connect the exhaust gas temperature sensor connector.

2. INSPECT FOR EXHAUST GAS LEAK

   Click here

3. INSTALL NO. 1 ENGINE COVER

   Click here