REAR DOOR WINDOW FRAME MOULDING REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  9. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  10. REMOVE REAR DOOR ARMREST COVER

    Click here

  11. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. REMOVE REAR DOOR TRIM BRACKET

    Click here

  13. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  14. REMOVE REAR DOOR GLASS RUN

    Click here

  15. REMOVE REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

    Click here

  16. REMOVE REAR DOOR REAR GUIDE SEAL

    Click here

  17. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  18. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

    Click here

  19. REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING

    Tech Tips

    When removing the rear door front window frame moulding, heat the vehicle body and rear door front window frame moulding using a heat light.

    Heating Temperature
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Moulding 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or rear door front window frame moulding moulding excessively.


    1. Using a heat light, heat the rear door front window frame moulding.

    2. B005YUEE02
      Text in Illustration
      *1 Double-sided Tape

      Using a moulding remover, disengage the clip and guide, and remove the rear door front window frame moulding.