ГЕНЕРАТОР ПОВТОРНАЯ СБОРКА


  1. INSTALL GENERATOR ROTOR ASSEMBLY


    1. Using a press, press in the rotor.

    2. Place the washer to the rotor.

  2. INSTALL RECTIFIER END FRAME


    1. B007QSXE02

      Using a 17 mm socket wrench and press, slowly press in the rectifier end frame.

    2. B007OUVE03

      Install the cord clamp and 4 nuts.

      Torque:
      5.9 N*m  { 60 kgf*cm, 53 in.*lbf }

  3. INSTALL GENERATOR HOLDER W/ RECTIFIER


    1. B007QMWE02

      Install the 4 rubber insulators on the lead wires.

      Note

      Be careful to install the rubber insulators in the correct direction.

    2. B007U5GE02

      While pushing down on the rectifier holder, install it with the 4 screws.

      Torque:
      2.9 N*m  { 30 kgf*cm, 26 in.*lbf }

  4. INSTALL BRUSH HOLDER AND REGULATOR


    1. B007PKUE01

      Install the regulator with the 3 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

    2. Place the seal plate.

    3. Install the brush holder with the 2 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

    4. Place the brush holder cover.

  5. INSTALL REAR END COVER


    1. B007W40E02

      Install the rear end cover and plate terminal with the bolt and 3 nuts.

      Torque:
      Nut
      4.4 N*m  { 45 kgf*cm, 39 in.*lbf }
      Bolt
      3.9 N*m  { 40 kgf*cm, 35 in.*lbf }

    2. Install the terminal insulator with the nut.

      Torque:
      4.1 N*m  { 42 kgf*cm, 36 in.*lbf }