ROOM TEMPERATURE SENSOR REMOVAL

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LHD with Entry and Start System)

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (except Sedan)

   Click here

4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (except Sedan)

   Click here

5. REMOVE NO. 1 METER HOOD CLUSTER (except Sedan)

   Click here

6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (except Sedan)

   Click here

7. REMOVE NO. 1 SWITCH HOLE BASE (except Sedan)

   for LHD:

   Click here

   for RHD:

   Click here

8. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for Sedan)

   Click here

9. REMOVE NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY (for Sedan)

   Click here

10. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for Sedan)

    Click here

11. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for Sedan)

    Click here

12. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Sedan)

    Click here

13. REMOVE NO. 1 SWITCH HOLE BASE (for Sedan)

    for LHD:

    Click here

    for RHD:

    Click here

14. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR

    1. 

       Disengage the 2 claws.

    2. 

       Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor.