CLUTCH ACCUMULATOR (for 5L-E, 2KD-FTV) INSTALLATION


  1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY


    1. B007SBE

      Install the clutch accumulator assembly with the 2 nuts.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

    2. Using a union nut wrench, connect the 2 clutch tubes.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench Click here.

  2. ADD BRAKE FLUID

    Fluid
    SAE J1703 or FMVSS No. 116 DOT3 or equivalent

    Note

    Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.

  3. BLEED CLUTCH LINE


    1. Fill the brake reservoir tank with brake fluid and bleed the clutch system.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  4. CHECK FOR BRAKE FLUID LEAKAGE

    Tech Tips

    Check for leakage in the clutch system.

  5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR


    1. Check the fluid level and add fluid if necessary.

      Fluid
      SAE J1703 or FMVSS No.116 DOT3 or equivalent

      Note

      Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.