BRAKE BOOSTER(for LHD) REASSEMBLY

PROCEDURE

  1. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

    1. Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.

      Note:

      Fully tighten the lock nut when adjusting the brake pedal height.

  2. INSTALL VACUUM SENSOR ASSEMBLY (for 1KR-FE with Stop and Start System, 1PP)

    1. Install a new check valve grommet to the brake booster assembly.

    2. C302761C01

      *a

      4.76° +/- 4°
      V100136

      Up

      Install the vacuum sensor assembly to the brake booster assembly as shown in the illustration.

      Note:

      • Push the area (A) when installing the vacuum sensor assembly.

      • Do not push the area (B) when installing the vacuum sensor assembly.

  3. INSTALL CHECK VALVE GROMMET

    1. Install a new check valve grommet to the brake booster assembly.