AIR FUEL RATIO SENSOR(w/o Glow Plug Controller) INSTALLATION

PROCEDURE

  1. INSTALL AIR FUEL RATIO SENSOR

    1. A293848C01

      *a

      Length of SST 30 mm (1.18 in.)

      *b

      Length of Torque Wrench 300 mm (11.8 in.)

      Using SST, install the air fuel ratio sensor onto the exhaust manifold converter sub-assembly.

      09224-00010

      without SST [Torque (N*m(kgf*cm, ft.*lbf))]

      44 N*m

      449 kgf*cm

      32 ft.*lbf

      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]

      40 N*m

      408 kgf*cm

      30 ft.*lbf

      Note:

      If a component has been dropped or subjected to a strong impact, replace it.

      Tip:

      • The "with SST" torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click hereClick hereClick hereClick here

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

  2. INSTALL WIRE HARNESS CLAMP BRACKET

    1. w/ No. 1 Engine Cover

      1. Install the wire harness clamp bracket.

      2. Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.

      3. Connect the connector to the air fuel ratio sensor.

    2. w/o No. 1 Engine Cover

      1. Install the wire harness clamp bracket.

      2. Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.

      3. Connect the connector to the air fuel ratio sensor.

      4. Install the nut.

        11 N*m

        112 kgf*cm

        8 ft.*lbf

  3. INSTALL NO. 2 ENGINE COVER BRACKET (w/ No. 1 Engine Cover)

    1. Install the No. 2 engine cover bracket with the 2 nuts.

      11 N*m

      112 kgf*cm

      8 ft.*lbf

  4. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click hereClick hereClick here

  5. INSTALL OUTER COWL TOP PANEL

    Tip:

  6. PERFORM INITIALIZATION

    Click here