HEADLIGHT LEVELING ECU INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY

    1. Install the headlight leveling ECU assembly with the bolt.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

    2. Connect the connector.

  2. INSTALL LOWER INSTRUMENT PANEL

    Click hereClick here

  3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  5. INSTALL BATTERY SERVICE COVER

    Click here

  6. INSTALL DECK BOARD ASSEMBLY

    Click here

  7. CHECK SRS WARNING LIGHT

    Click here

  8. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL

    Click here