ANTI-LOCK BRAKE SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the GTS on.

    6. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    7. According to the display on the GTS, read the Data List.

      Chassis > ABS/VSC/TRC > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      ABS Warning Light

      ABS warning light

      ON or OFF

      ON: Warning light on

      OFF: Warning light off

      -

      Brake Warning Light

      Brake warning light

      ON or OFF

      ON: Warning light on

      OFF: Warning light off

      -

      Stop Light SW

      Stop light switch

      ON or OFF

      ON: Brake pedal depressed

      OFF: Brake pedal released

      -

      Parking Brake SW

      Parking brake switch

      ON or OFF

      ON: Parking brake applied

      OFF: Parking brake released

      -

      FR Wheel Speed

      Front wheel speed sensor RH reading

      Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)

      Vehicle stopped: 0 km/h (0 mph)

      When driving at constant speed: No large fluctuations

      FL Wheel Speed

      Front wheel speed sensor LH reading

      Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)

      Vehicle stopped: 0 km/h (0 mph)

      When driving at constant speed: No large fluctuations

      RR Wheel Speed

      Rear wheel speed sensor RH reading

      Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)

      Vehicle stopped: 0 km/h (0 mph)

      When driving at constant speed: No large fluctuations

      RL Wheel Speed

      Rear wheel speed sensor LH reading

      Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)

      Vehicle stopped: 0 km/h (0 mph)

      When driving at constant speed: No large fluctuations

      Vehicle Speed

      Maximum wheel speed sensor reading

      Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)

      Vehicle stopped: 0 km/h (0 mph)

      When driving at constant speed: No large fluctuations

      FR Wheel Acceleration

      Front wheel RH acceleration

      Min.: -200.84 m/s2, Max.: 199.27 m/s2

      -

      During deceleration/acceleration: Changes continuously

      FL Wheel Acceleration

      Front wheel LH acceleration

      Min.: -200.84 m/s2, Max.: 199.27 m/s2

      -

      During deceleration/acceleration: Changes continuously

      RR Wheel Acceleration

      Rear wheel RH acceleration

      Min.: -200.84 m/s2, Max.: 199.27 m/s2

      -

      During deceleration/acceleration: Changes continuously

      RL Wheel Acceleration

      Rear wheel LH acceleration

      Min.: -200.84 m/s2, Max.: 199.27 m/s2

      -

      During deceleration/acceleration: Changes continuously

      FR Wheel ABS Ctrl Status

      Front wheel RH ABS control status

      ON or OFF

      ON: During control

      -

      FL Wheel ABS Ctrl Status

      Front wheel LH ABS control status

      ON or OFF

      ON: During control

      -

      RR Wheel ABS Ctrl Status

      Rear wheel RH ABS control status

      ON or OFF

      ON: During control

      -

      RL Wheel ABS Ctrl Status

      Rear wheel LH ABS control status

      ON or OFF

      ON: During control

      -

      FR Wheel EBD Ctrl Status

      Front wheel RH EBD control status

      ON or OFF

      ON: During control

      -

      FL Wheel EBD Ctrl Status

      Front wheel LH EBD control status

      ON or OFF

      ON: During control

      -

      RR Wheel EBD Ctrl Status

      Rear wheel RH EBD control status

      ON or OFF

      ON: During control

      -

      RL Wheel EBD Ctrl Status

      Rear wheel LH EBD control status

      ON or OFF

      ON: During control

      -

      Solenoid Relay

      ABS solenoid relay

      ON or OFF

      ON: ABS solenoid relay on

      OFF: ABS solenoid relay off

      -

      ECB Motor Relay

      ABS motor relay

      ON or OFF

      ON: ABS motor relay on

      OFF: ABS motor relay off

      ECB: Electronically Controlled Brake

      ABS Solenoid (SFRH)

      ABS solenoid (SFRH)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SFRR)

      ABS solenoid (SFRR)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SFLH)

      ABS solenoid (SFLH)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SFLR)

      ABS solenoid (SFLR)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SRRH)

      ABS solenoid (SRRH)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SRRR)

      ABS solenoid (SRRR)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SRLH)

      ABS solenoid (SRLH)

      ON or OFF

      ON: During control

      -

      ABS Solenoid (SRLR)

      ABS solenoid (SRLR)

      ON or OFF

      ON: During control

      -

      IG1 Voltage Value

      IG1 voltage value

      Min.: 0.00 V, Max.: 20.00 V

      -

      Changes in proportion to battery voltage

      BS1 Voltage Value

      +BS voltage value

      Min.: 0.00 V, Max.: 20.00 V

      -

      Changes in proportion to battery voltage

      MT Voltage Value

      Motor voltage value

      Min.: 0.00 V, Max.: 20.00 V

      -

      Changes in proportion to battery voltage

      Number of DTC

      Number of DTC recorded

      Min.: 0, Max.: 255

      -

      -

      IG Voltage Value Decreased

      +BS voltage value decrease detection

      Error or Normal

      Error: Voltage low

      Normal: Normal

      -

      IG Voltage Value Increased

      +BS voltage value increase detection

      Error or Normal

      Error: Voltage high

      Normal: Normal

      -

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed.

    Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the GTS on.

    6. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

    7. According to the display on the GTS, perform the Active Test.

      Chassis > ABS/VSC/TRC > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      ABS Warning Light

      ABS warning light

      Warning light ON/OFF

      Observe combination meter assembly

      Brake Warning Light

      Brake warning light

      Warning light ON/OFF

      Observe combination meter assembly

      Motor Relay

      ABS motor relay

      Relay ON/OFF

      Operating sound of motor can be heard

      ABS Solenoid (SRLR)

      ABS solenoid (SRLR)

      Solenoid ON/OFF

      -

      ABS Solenoid (SRLH)

      ABS solenoid (SRLH)

      Solenoid ON/OFF

      -

      ABS Solenoid (SRRR)

      ABS solenoid (SRRR)

      Solenoid ON/OFF

      -

      ABS Solenoid (SRRH)

      ABS solenoid (SRRH)

      Solenoid ON/OFF

      -

      ABS Solenoid (SFLR)

      ABS solenoid (SFLR)

      Solenoid ON/OFF

      -

      ABS Solenoid (SFLH)

      ABS solenoid (SFLH)

      Solenoid ON/OFF

      -

      ABS Solenoid (SFRR)

      ABS solenoid (SFRR)

      Solenoid ON/OFF

      -

      ABS Solenoid (SFRH)

      ABS solenoid (SFRH)

      Solenoid ON/OFF

      -

      ABS Solenoid

      ABS solenoid (SRLR, SRLH, SRRR, SRRH, SFLR, SFLH, SFRR, SFRH)

      Solenoid SRLR/SRLH/SRRR/

      SRRH/SFLR/SFLH/SFRR/SFRH

      Operation sound of solenoid (clicking sound) can be heard