AUTOMATIC TRANSMISSION SYSTEM(for V35A-FTS), Diagnostic DTC:U110387

DTC Code DTC Name
U110387 Lost Communication with Stop and Start Control Module Missing Message

DESCRIPTION

The ECM and engine stop and start ECU send and receive signals via CAN communication.

If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
U110387 Lost Communication with Stop and Start Control Module Missing Message While the engine switch is on (IG), there is no communication between the ECM and engine stop and start ECU for 1.16 seconds or more (1-trip detection logic).

  • ECM

  • Engine Stop and Start ECU

  • CAN Communication System

 Does not come on DTC stored SAE: U1103

CONFIRMATION DRIVING PATTERN

Tech Tips

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.


  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG) and turn the GTS on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  4. Turn the engine switch off and wait for at least 30 seconds.

  5. Turn the engine switch on (IG) and turn the GTS on.

  6. Enter the following menus: Powertrain / Transmission / Utility / All Readiness.

  7. Input the DTC: U110387.

  8. Check the DTC judgment result.

    GTS Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions
    N/A

    • Unable to perform DTC judgment

    • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

    • If the judgment result shows INCOMPLETE or N/A, perform the Confirmation Driving Pattern and check the DTC judgment result again.

CAUTION / NOTICE / HINT

Note

Perform registration and/or initialization when parts related to the automatic transmission are replaced.

Click here

PROCEDURE


  1. CLEAR DTC AND PERFORM ROAD TEST


    1. Clear the DTCs.

      Click here


      Powertrain > Transmission > Clear DTCs

      Tech Tips

      Write down the currently output DTCs before clearing them.

    2. Start the engine and drive the vehicle at a low speed.

      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK DTC OUTPUT (DTC U110387)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Transmission / Trouble Codes.


      Powertrain > Transmission > Trouble Codes

    5. Read the DTCs using the GTS.

      Result
      Result Proceed to
      DTC U110387 is not output A
      DTC U110387 is output B

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

    B

    GO TO CAN COMMUNICATION SYSTEM Click here