FUEL SENDER GAUGE ASSEMBLY INSPECTION

PROCEDURE

  1. INSPECT FUEL SENDER GAUGE ASSEMBLY

    1. Check that the float moves smoothly between F and E.

    2. A286566C03

      *a

      Component without wire harness connected

      (Fuel Sender Gauge Assembly)

      Check the fuel sender gauge assembly resistance.

      1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

        Standard Resistance

        Float Level

        Resistance (Ω)

        F

        12.0 to 18.0

        Between E and F

        12.0 to 415.0 (Gradually changes)

        E

        405.0 to 415.0

        If the result is not as specified, replace the fuel sender gauge assembly.